Problems fixed in IO Checker 3.1 Revision 3, June 17, 2015

1639 Incorrect warning messages when updating the constraint file 3.1.1 When a constraint file (that is specified with a relative path) is updated by the constraint writer to the same file (but showing an absolute path) a lot of (incorrect) warnings are generated.
1635 Make View filter settings part of the project data 3.1.1 The view filter settings are stored in the IO Checker user configuration. However in each project you can have different data (like no constraints) and want to hide these columns. When loading another project with constraints they should be visible again.
1614 Signal index not shown in PCB tooltip 3.1.1 A PCB signalname like 'test<0>' as always shown as 'test' in the tooltip of the PCB column.
1575 Write pin names in the Xilinx XDC generator aligned 3.1.1 Write all pins names in a string extended to 4 chararcter for the best alignment.
1541 Constraint generation dialog accepts directory path which does not exist 3.1.1 When a new constraint file (on a directory that doesn't exists) is specified the dialog is closed, but IO Checker doesn't write the file. This filename is however added to the IO Checker project.
  Altera 3.1.1 Added Arria 10 and MAX10 devices
  Xilinx 3.1.1 Updates for Artix-7, Kintex-7, Kintex UltraScale, Virtex-7, Virtex UltraScale and Zynq devices
  Microsemi 3.1.1 updates for Igloo2, SmartFusion2 and ProASIC3 devices
  Lattice 3.1.1 Added ECP5 and MacOX3 devices
Home dot Company dot Products dot Sales dot Support dot HDL Corner dot Site Map
Copyright © 2004 - 2019 HDL Works